Installation Instructions

Our floating shelfs are strong and have been independently weight tested However they can only be as strong as the substrate and the wall fixings used.

Other installation applications can be used but we recommend the following:
Hardware Supplied: 2 X Wood Screws for stud fixing Stick on Wood Screw covers.
Tools

Fixing Essential information

1. To achieve maximum load rating when mounting onto plasterboard stud wall, ensure that the fixing goes into studs recommended for each kit as below.
   - 400 double lined back plate fix to at least one stud spread weight evenly (see video instructions)
   - 600 Single lined back plate fix to at least one stud plus a plaster wall mate
   - 800 Single lined back plate fix to at least two studs one at each end (see video instructions)
   - 800 Single lined back with small shelf and wardrobe hanging fix to at least two studs one at each end
   (see video instructions)
   - 800 double lined back plate multiroom kit obtain 4 fixings into studs (see instructional video)
   - 800 double lined back wardrobe with deep top shelf obtain 4 fixings into studs (see instructional video)
2. Note that when anchoring to plasterboard wall, the anchors are only as strong as the wall they are mounted into.
3. Make sure you distribute the load evenly when dressing shelves with accessories.

Step by step installation instructions

1. Panels may be affixed to existing wall. We recommend they should be affixed directly to the studs
2. Use a stud finder to find the studs in the wall
3. Use a level and mark your studs (two studs for 600mm and 800mm and at least 1 stud for 300mm and 400mm panels
4. Ensure back panel is installed right way up. In absence of direction sticker, test by trying to insert a shelf or accessory. Hold shelf the correct way up (insert back panel at back of shelf in downwards direction) and attempt to insert shelf in back panel. If back panel upside down the shelf/accessory will not fit flush and be at an angle to back panel
5. Use your drill and counter sunk drill bit to drill a hole through the backboard and wall where you have marked your studs. For 400mm and 300mm panels, ensure at least one stud is utilised. Another screw can be added, below the first screw, into the stud, if required.
6. Use the two wood screws and Phillips Head Screwdriver to screw through the back board, into the wall until it is flush with the surface of the wall.
7. Attach your shelf and accessories.
8. Any installation variation to above recommendations or modification of product voids any liability by the manufacturer.

Customer Information
This product is a shelving system – for product weights within its weight rating guidelines. It is not for any other use and not for climbing on.
Installation of product should be completed to ensure adequate anchoring and or fixing to your relevant surface. Overloading or incorrect use may cause failure of product and or injury. If shelves detach from brackets cease to use. No liability accepted if use is continued.

Check product upon delivery and inspect for any defects. Immediately contact freight carrier if damaged in transit. Defects in product should be immediately notified to supplier within Shelf N More warranty guidelines as set out on our website.

Clean and remove dust and other foreign matter using a clean, slightly damp cloth, do not use solvents or excessive water as panelling will expand with moisture and integrity of panel will degrade. Any variation or modification of the product may cause failure and will void any liability of the manufacturer.
Any use of any of the parts or components in any other product voids liability of the manufacturer.

No other products may be used in conjunction with this system. Shelf N More does not take responsibility for liability if other products are attached to this system. Shelf N More limits its warranty to replacement only if the
product is defective.